TEF ZEOS-C

TEF ZEOS-C manual

(1)
  • www.tefbrandbeveiliging.nl Tel: 0180 - 554555
    FIRE ALARM DETECTOR
    TECHNICAL SPECIFICATIONS
    INSTALLATION
    INSTALLING THE BASE
    To ensure proper fit of the detector head to the base, all wires should be properly dressed at installation by positioning all wires flat
    against terminals and fastening the wires away from connector terminals. The detector base can be mounted directly onto most standard
    electrical junction boxes.
    INSTALLING THE HEAD
    Align detector components using provided alignment marks on both the head and base. Align detector mark and short alignment mark on
    base. Fit the detector head onto the base and twist clockwise to secure it. After all detectors are installed, apply power to the control unit .
    Test the detectors as described below.
    TESTING
    All remote signalling systems, releasing devices and extinguishing systems should be disconnected during the test period and
    reconnected at the conclusion of testing. After powering the detector, check to see the indicator LED flashing every 5 seconds. If the LED
    fails to flash, it indicates the non-functioning of the detector or fault wiring. Re-check the wiring or replace the detector if necessary.
    SMOKE: Allow smoke from a cotton wick or test smoke aerosol to enter the detector’s smoke chamber for at least 10 seconds. When
    sufficient smoke has entered, the detector will signal an alarm. This will be indicated by the illumination of the 2 Red LEDs provided. Make
    sure to clear smoke out of the chamber before resetting in order to keep the detector at its current sensitivity setting.
    HEAT: The detector to be tested should be subject to a flow of warm air at a temperature of between 65°C and 80°C. This requirement can
    be met by some domestic hair dryers. Switch on the warm airflow and check that the temperature is correct and stable. From a distance of
    several cms, direct the airflow at the guard protecting the thermistor. The detector should alarm within 60 seconds. Upon alarm
    immediately remove the heat source and check that the Red LEDs of the detector are illuminated. If a detector fails to activate within 60
    seconds, confirm connections and programming. If necessary replace unit. Note: After testing, check that the system is returned to
    normal operation. Notify the appropriate authorities that the testing procedure has been completed and the system is active again.
    MAINTENANCE
    The recommended minimum requirement for detector maintenance consists of annual cleaning of dust from the detector head using a
    low power vacuum cleaner. >> DO NOT ATTEMPT TO DISASSEMBLE THE DETECTOR
    Detector Head
    Detector Base
    Alignment Marks
    ZEOS-C
    ma_zeosc_01_010001_en_180716
    MADE IN PORTUGAL - EU
    10 V to 30 V DC
    Heat: 7 uA / Smoke: 33 uA / Smoke & Heat: 35 uA
    24 mA - Alarm LEDs
    According to EN54-5 or/and EN54-7
    0.5-2.5 mm²
    20 seconds max.
    White / ABS
    95% RH Non-Condensing
    0°C to 50°C / -10°C to 85°C
    100 mm (D) x 50 mm (H) inc. base / 144 g inc. base
    ORION, ORION MINI, ORION EX, ORION-PLUS, QUAD ZMU and ZMU
    SUPPLY VOLTAGE
    CURRENT - QUIESCENT
    CURRENT - DEVICE IN ALARM
    SENSITIVITY
    CABLE SIZE
    RESET/START-UP TIMES
    COLOUR / CASE MATERIAL
    MAX. HUMIDITY
    NORMAL / TRANSIENT OPER. TEMPERATURE
    DIMENSIONS / WEIGHT
    COMPATIBILITY
    ORDER CODE
    DESCRIPTION
    ZEOS-C-S
    ZEOS-C-H
    ZEOS-C-SH
    | CERTIFICATE |
    PHOTOELECTRIC SMOKE DETECTOR
    RATE OF RISE/FIXED TEMP HEAT DETECTOR
    MULTISENSOR SMOKE & HEAT DETECTOR
    1328-CPR-0705
    1328-CPR-0706
    1328-CPR-0704
    MECHANICAL SPECIFICATION
TEF ZEOS-C

Brug for hjælp?

Antal spørgsmål: 0

Har du et spørgsmål om TEF ZEOS-C eller har du brug for hjælp? Stil dit spørgsmål her. Giv en klar og omfattende beskrivelse af problemet og dit spørgsmål. Jo flere oplysninger du giver om dit problem og dit spørgsmål, jo lettere er det for andre TEF ZEOS-C ejere at svare korrekt på dit spørgsmål.

Se manualen til her gratis. Denne vejledning hører under kategorien og er blevet bedømt af personer med et gennemsnit på en . Denne manual er tilgængelig på følgende sprog: . Har du et spørgsmål om eller har du brug for hjælp? Stil dit spørgsmål her

Vi anvender cookies for at sikre at vi giver dig den bedst mulige oplevelse af vores website. Hvis du fortsætter med at bruge dette site vil vi antage at du er indforstået med det.

Læs mere