STEM OR HANDLEBAR?
INSTALLATION OF THE BRACKET
1.2 1.3 1.4
1. INSTALLATION OF THE BRACKET
INSTALLATION OF THE POWER MAGNET
INSTALLATION OF THE CADANCE MAGNET
ADJUSTING OF POWER MAGNET
ADJUSTING OF POWER MAGNET
In order to achieve the
necessary 12 mm or less
install the transmitter and
the magnet closer to the
3. INSTALLATION OF THE WIRELESS CADENCE TRANSMITTER
ROX 10.0 GPS INSTALLATION ON THE BIKE
2. INSTALLATION OF THE WIRELESS SPEED TRANSMITTER
INSTALLATION ON THE BIKE
- Julius - Leber - Straße 15
- 67433 Neustadt / Weinstraße
SIGMA SPORT ASIA
4F, No.192, Zhonggong 2
Xitun Dist., Taichung City 407, Taiwan
SIGMA SPORT USA
3487 Swenson Ave.
St. Charles, IL 60174, U.S.A.
This device complies with part 15 of th
e FCC Rules. Operation is subject to the following two
This device may not cause harmful interference,
this device must accept any interference received, including interference
th at may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates,
uses and can radi
ate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s auth
ority to operate the equipment.
This device complies with Industry Canad
a licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
this device may not cause interference,
this device must accept any interference, including interference that may cause undesired
operation of th e device.
This Class digital apparatus complies with
FIND THE COMPLETE MANUAL,
INSTALLATION AND SETTING VIDEOS
081000-1_Montageanleitung ROX 10.0_600x280.indd 1