Philips Walita Viva Collection RI1845 manual

Philips Walita Viva Collection RI1845
(1)
  • Antal sider: 2
  • Filtype: PDF
a
o
n
m
l
j
i
h
g
v
u
w
x
y
t
s
r
q
p
b
c
d
f
e
k
e subject to change without notice
©2012 Koninklijke Philips Electronics N.V.
All rights reserved.
EN
Congratulations on your purchase, and welcome to Philips!
To fully benet from the support that Philips offers, register your product at www.Philips.com/welcome.

1 Important

Safety
Read this user manual carefully before you use this 4-in-1 juicer and save it for future reference.
Danger
Don't immerse the motor unit of the juicer in water, any other uid, nor rinse it under the tap. Use only a moist
cloth to clean.
Warning
Check if the voltage indicated on the juicer corresponds to the local power voltage before you connect it.
Only connect the juicer to a grounded power outlet. Always make sure that the plug is inserted rmly into the power outlet.
Do not use the appliance if the plug, the power cord, or other components are damaged.
Assemble the juicer properly before plugging it into the power outlet.
Make sure that the damaged power cord is replaced by Philips, a service center authorized by Philips or similarly
qualied persons in order to avoid a hazard.
Avoid touching the sharp blades, especially when you clean them and when the juicer is still connected to power outlet.
The appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to make sure that they do not play with the juicer.
Keep the power cord out of the reach of children. Do not let the power cord hang over the edge of the table
or worktop on which the juicer stands.
Do not plug in the juicer or press any of the buttons on the control panel with wet hands.
Never use the accessories to turn the juicer on and off. Never let the juicer operate unattended.
Make sure the blade unit is securely fastened to the accessories before you assemble them onto the motor unit.
Caution
Never use any accessories or parts from other manufacturers or that Philips does not specically recommend. If
you use such accessories or parts, your guarantee becomes invalid.
Do not remove accessories from the motor unit when the juicer is working.
Never reach into the jar or bowl with your ngers or an object while the juicer is running.
Do not exceed the quantities and processing times indicated in the recipe section.
Unplug the juicer immediately after use, e.g. before unscrewing the jar.
Avoid touching the sharp blades, especially when the juicer is still connected to power outlet.
If the blades get stuck, unplug the appliance before removing the ingredients that are blocking the blades by using a spatula.
Place the juicer on a stable, horizontal, and level surface.
Switch off and unplug the juicer from the power supply before you take out and insert any accessories from the main unit.
Always let the juicer cool down before you clean or move it.
Always clean the juicer after use. You can clean the juicer in dishwasher.
Always unplug the juicer if not used for a longer period. This appliance is intended for household use only.
Make sure all parts are correctly mounted before you switch on the appliance.
Only use the appliance when both clamps are locked and unlock the clamps after you have switched off the
appliance.
Food coloring can discolor components. This is normal and has no impact on use.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled properly and according
to the instructions in this user manual, the appliance is safe to use based on scientic evidence available today.
Built-in safety lock
This feature ensures that you can only switch on the appliance if the blender jar and lid, the mill beaker or the chopper
bowl and blade unit (specic types only) are assembled on the motor unit properly.
If the blender jar and lid, the mill beaker or the chopper bowl and blade unit are correctly assembled, the
built-in safety lock will be unlocked.

2 Overview

a
Measuring cup
n
Chopper rubber ring (HR1847 and HR 1848 only)
b
Blender jar lid
o
Chopper beaker (HR1847 and HR 1848 only)
c
Blender jar
p
Pusher
d
Blender rubber ring
q
Feeding tube
e
Blender blade unit
r
Lid
f
Central base
s
Sieve
g
Juice container
t
Juice collector
h
Juice container cover Spout
u
Locking clips
i
Spout
v
Driving shaft
j
Mill blade unit (HR1846, HR1847, and HR 1848 only)
w
Pulp container
k
Mill rubber ring (HR1846, HR1847, and HR 1848 only)
x
Switch
l
Mill beaker (HR1846, HR1847, and HR 1848 only)
y
Motor unit
m
Chopper blade unit (HR1847 and HR 1848 only)

3 Before first use

1 Take out all the accessories.
2 Clean the parts of the juicer thoroughly before using the juicer for the rst time (see chapter ‘Cleaning’).
3 Make sure all parts are completely dry before you start using the juicer.

4 Using the juicer

Extracting Juice
The juicer can be used for preparing fresh fruit juices. Pulp, pips and skins will be separated.
Follow the assembling steps for extracting juice.
Make sure the control switch is off. Then, connect to the power socket.
1 Clean and cut large ingredients into pieces that t into the feeding tube.2 Turn the control switch to the suggested speed.3 Put your ingredients through the feeding tube.4 Push the ingredients gently down with the pusher.
Tips
Remove stones from cherries, plums, peaches, etc. You do not have to remove cores or seeds from fruits like
melons, apples and grapes.
Use fresh fruit and vegetables; they contain more juice. Particularly suitable for processing in the juice extractor
are pineapples, beetroots, celery stalks, apples, cucumbers, carrots, spinach, melons, tomatoes, oranges and grapes.
You do not have to remove thin peels or skins. Only remove thick peels, e.g. those of oranges, pineapples and
uncooked beetroots. Also remove the white pith of citrus fruits because it has a bitter taste.
When you prepare apple juice, remember that the thickness of the apple juice depends on the apple you are
using. The juicier the apple the thinner the juice. Choose an apple that produces the type of juice you prefer.
Apple juice turns brown very quickly. You can slow down this process by adding a few drops of lemon juice.
Fruits that contain starch, such as bananas, papayas, avocados, gs and mangoes are not suitable for processing in
the juice extractor. Use a food processor, blender or bar blender to process these fruits.
Leaves and leafstalks of e.g. lettuce can also be processed in the juice extractor.
Drink the juice immediately after you have extracted it. If it is exposed to air for some time, the juice will lose its
taste and nutritional value.
You can get more juice output if you use softer force to push the fruit and vegetables down.
Notes
Do not exert too much pressure on the pusher, since this would affect the quality of the end result and it could
even cause the sieve to come to a halt.
Do not run the juicer continuously for more than 2 minutes. If you have not nished extracting juice, switch the
juicer off, and allow it to cool down to room temperature before you continue processing.
Do not reach into the sieve through the pulp outlet of the pulp collector.
Blending
The blender is intended for:
Blending uids, for examples dairy products, sauces, fruit juices, soups, mixed drinks, shakes;
Mixing soft ingredients, for examples pancake batter or mayonnaise;
Pureeing cooked ingredients, for example making baby food.
Follow the assembling steps for blending. Remember to install the blender rubber ring before use.
Blending
1 Mount the the knife unit onto the jar. Fix it by turning it in the direction of the arrow.
2 Turn and lock the blender jar onto the motor unit until it locks into position, and you hear a click sound..
3 Clean and cut large ingredients into pieces, and put them in the blender jar.4 Press the lid into place.5 Place the measuring cup into the opening in the lid until it is rmly xed.6 Make sure the control switch is off. Then, connect to the power socket.7 Turn the control switch to the suggested speed. 8 Once complete, switch off and unplug. Remove the blender jar from the motor unit.9 Pour out the drink through the spout of the blender jar.Notes Dry ingredients must not be processed for more than 1 minute.
While the motor is running, ingredients (for examples: ice cubes and tomatoes) can be added into the blender
through the opening in the lid.
Make sure to position the sieve of the lid is in front of the spout of the jar for smooth liquid pouring.
To disassemble the blender, follow the instructions above in reverse order and direction.
Refer to the end of this user manual for the recommended quantities, speed settings, and processing time.
Cautions Be careful not to exert too much pressure on the handle of the jar.
Never ll the jar with ingredients that have a temperature of over 60°C.
Never overll the blender jar above the maximum level indication (1.0 liters) to avoid spillage.
Always insert the measuring cup into the lid before you start processing.
Do not run the blender for more than 3 minutes at a time. If you have not nished blending after 3 minutes,
switch the blender off and let it cool down to room temperature before you continue processing.
Never put your hand or any object in the jar while the blender is running.
Always set the control knob to 0 before you open the lid.
Grinding
The mill attachment can be used for grinding dry ingredients only.
Follow the assembling steps for grinding dry ingredients. Remember to install the mill rubber ring before use.
Put the ingredients in the beaker.
1 Screw the blade unit onto the beaker. Fix it by turning it in the direction of the arrow.
2 Turn the assembled mill upside down, place and lock it on the motor unit.3 Turn the control switch to the suggested speed.4 Once complete, switch off, unlock, and remove the mill from the motor unit.5 Unscrew the blade unit from the beaker. Notes
The mill is not suitable for chopping very hard ingredients like nutmeg and ice cubes.
Do not ll the beaker beyond the maximum indication. See the table for the advised quantities.
Never use the mill for more than 30 seconds without interruption.
RI1845_HR1846_HR1847_HR1848_UM_PT-BR_V1.0_120607
314003530241
Registre seu produto e obtenha suporte em

www.philips.com/welcome

RI1845
HR1846
HR1847
HR1848

EN User manual

PT-BR Manual do Usuário

Philips Walita Viva Collection RI1845

Brug for hjælp?

Antal spørgsmål: 0

Har du et spørgsmål om Philips Walita Viva Collection RI1845 eller har du brug for hjælp? Stil dit spørgsmål her. Giv en klar og omfattende beskrivelse af problemet og dit spørgsmål. Jo flere oplysninger du giver om dit problem og dit spørgsmål, jo lettere er det for andre Philips Walita Viva Collection RI1845 ejere at svare korrekt på dit spørgsmål.

Se manualen til Philips Walita Viva Collection RI1845 her gratis. Denne vejledning hører under kategorien Saftpressere og er blevet bedømt af 1 personer med et gennemsnit på en 7.5. Denne manual er tilgængelig på følgende sprog: Engelsk. Har du et spørgsmål om Philips Walita Viva Collection RI1845 eller har du brug for hjælp? Stil dit spørgsmål her

Philips Walita Viva Collection RI1845 specifikationer

Generelt
Mærke Philips
Model Walita Viva Collection RI1845
Produkt Saftpresser
Sprog Engelsk
Filtype PDF
Funktioner
Antal hastigheder 2
Beholder til frugtkød 0.5 L
Blenderskål volumen 1 L
Ledningsopbevaring Ja
Sikkerhedsklemmer Ja
Ledningslængde 1.2 m
Produktfarve Orange,White
Materiale
Materiale, kabinet & klemmer PP
Lågmateriale SAN
Strømstyring
Strøm 350 W
Vekselstrømsindgangsspænding 220-240 V
Vekselstrømsindgangsfrekvens 50 - 60 Hz
Emballeringsdata
Sugefødder Ja
vis mere

Ofte stillede spørgsmål

Nedenfor finder du de hyppigst stillede spørgsmål om Philips Walita Viva Collection RI1845.

Er dit spørgsmål ikke angivet? Stil dit spørgsmål her