JL Audio DRC-205

JL Audio DRC-205 manual

(1)
  • Limited
    Warranty-
    Electronics
    (USA)
    )L
    Audio
    warrants this
    product
    to
    be free
    of
    defects in materials
    and
    wo
    rkmanship
    for
    a period
    of
    two
    (2) years
    from
    the
    original date
    of
    purchase. This warranty
    is
    not
    transferable a
    nd
    applies
    only
    to
    the original purchaser
    from
    an
    authorized
    JL
    Audio dealer. Should
    se
    rvice be necessary
    under
    this
    war
    r
    anty
    for
    any reason due
    to
    manufacturing
    defect
    or
    malfunction,
    JL
    Audio
    will
    (at its discretion), repair
    pr
    replace
    th
    e defective
    product
    with
    new
    or
    remanufactured
    product
    at
    no
    charge. Damage
    ca
    used
    by
    the
    following
    ls
    not
    covered
    under
    wa
    rranty: accident, misuse,
    abuse, pr
    oduct
    modification
    or
    neglect, failure
    to
    follow
    installation instructions,
    unauth
    orized
    repair attempts, misrepresentations
    by
    the
    seller. This warranty does
    not
    cover incidental
    or
    consequential damages and does
    not
    cover the cost
    of
    removing
    or
    reinstalling
    the
    unit(s).
    Cosmetic damage due
    to
    accident
    or
    normal wear and tear
    is
    not
    covered
    under
    warranty.
    Warranty
    is
    void
    if
    the
    product
    's serial
    number
    has
    been
    removed
    or
    defaced
    .
    Any
    app
    licable
    implied
    warranti
    es
    are
    limited
    in
    duration
    to
    the
    period
    of
    the
    express warra
    nty
    as
    provided
    herein
    beginning
    with
    the
    date
    of
    the
    original purchase
    at
    retail, and
    no
    warranties,
    whet
    her
    expr
    ess
    or
    implied,
    shall
    apply
    to
    this
    product
    thereafter. Some states
    do
    not
    allow
    limitations
    on
    implied
    warranties, therefore these exclusions may
    not
    apply
    to
    you. This
    warranty
    gives
    you
    specific legal rights, and you may also have
    other
    right
    s,
    which
    vary
    from
    state
    to
    stat
    e.
    If
    you
    need
    service
    on
    your
    JL AUDIO
    product
    :
    All warranty returns s
    hould
    be sent
    to
    JL
    Audio
    's
    Electronics Service Facility
    freight
    -prepaid
    through
    an
    au
    th
    orized
    JL
    Audio dealer and must be accompanied
    by
    proof
    of
    pur
    chase
    (a
    copy
    of
    the
    original
    sa
    l
    es
    receipt
    ).
    Di
    rect
    returns from consumers or
    non
    -aut
    horized dealers
    wi
    ll be
    refused unl
    ess
    specifically a
    uthor
    ized
    by
    JL
    Audio
    with
    a valid
    return
    au
    th
    orization
    number
    .
    Warr
    anty
    ex
    piration
    on
    products
    returned
    wi
    th
    out
    proof
    of
    pur
    chase will
    be
    determined
    from
    the manufacturing date code. Coverage may
    be
    invalidated
    as
    this
    date
    is previous
    to
    purchase
    date. Non-defective ·items received
    will
    be returned freight-collect. Customer is responsible
    for
    sh
    ipping
    charges and insurance in
    se
    nding
    the
    product
    to
    JL
    Audio. Freig
    ht
    damage
    on
    returns is
    not
    covered un
    der
    war
    ra
    nty.
    For
    Service
    Information
    in
    the
    U.S.
    A.
    please
    call
    JL
    Audio
    Customer
    Service:
    (9S4)
    443-1100
    9:00AM-
    S:30
    PM
    (Eastern Time Zone)
    JL
    Audio,
    Inc.
    10369
    North
    Commerce Pkwy. Miramar,
    FL
    3302S
    (
    Do
    not
    se
    nd
    product
    for repair
    to
    thi
    s addr
    ess)
    International
    Warranties:
    Pr
    oducts
    purchased
    outs
    id
    e
    the
    United
    Sta
    t
    es
    of
    America are covered
    only
    by
    that
    country's
    distributor
    and
    not
    by
    JL
    Aud
    io
    , Inc.
    JL
    Audio• and the
    JL
    Audio logo are registered trademarks
    of
    JL
    Audio,
    Inc
    CJ2018
    JL
    Audio, lnc.
    For
    more detailed information
    please
    visit
    us
    online at
    www
    .jla
    udio.com. Due
    to
    our policy of continuous product development, all specifications
    are
    subject
    to change without notice.
    DRC205
    _
    MAN
    _
    053018
    This product will
    not
    work
    with
    JL
    Audio amplifiers
    with
    "Remote
    Lev
    el
    Control"
    or
    "Remote
    Bass
    Control Ports
    ".
    Control Knob Installation:
    1.
    Find
    an
    appropriate location to mount
    the
    Control
    Knob
    assembly
    on the
    dash
    or console
    of
    the
    vehicle.
    You
    will need
    access
    to
    the
    rear
    of
    the mounting
    panel
    for
    installation.
    The
    area
    will
    require
    the following minimum
    and
    maximum
    dimensions:
    Area
    Beh
    ind
    Panel:
    1"
    square
    x
    1"
    deep
    (25mm
    x 25mm x
    25mm)
    Mounting
    Panel
    Thickness:
    1/4
    inch
    (6mm)
    maximum
    2.
    Dr
    ill
    a 5/8"
    (16mm)
    hole
    in
    the center
    of
    the mounting
    area.
    3.
    Remove
    the
    knobs
    (inner,
    then
    outer)
    from the controller's
    shaft
    and remove the
    thumbnut from the
    clear
    threaded
    sleeve.
    4.
    From
    behind, insert the controller's
    shaft
    through the drilled hole
    and
    push
    forward.
    5.
    From
    the front, hand-tighten the thumbnut onto the
    clear
    threaded
    sleeve.
    Note:
    If
    needed, three plas
    ti
    c s
    pacers
    are
    included to adjust the overall protrusion
    of
    th
    e
    controller's shaft. Depending on mounting panel thickness and desired shaft heig
    ht
    ,
    pl
    ace
    1, 2 or 3 sp
    ace
    rs over
    th
    e clear threaded sleeve prior
    to
    performing step
    4.
    6.
    Turn
    each
    control fully counter-clockwise and
    place
    the
    knobs
    on the
    shaft
    (outer,
    then
    inner)
    with their
    markers
    pointing
    at
    7:00.
    7.
    Route
    one end
    of
    the control
    cable
    to
    the
    port
    of
    a compatible Jlid'"-equipped
    device
    and
    connect the other end to the
    harness
    jack of the
    DRC-205
    controller.
    8.
    Specific
    contr
    ol
    functionality wi
    ll
    vary
    depending on the connected
    Jlid'"
    product and/
    or TuN'" configuration.
    Optional Mounting Clip Installation:
    A mounting clip
    is
    included to
    secure
    the
    harness
    jack
    module.
    Use
    the supp
    li
    ed
    screws
    to
    fasten
    the mounting clip to a fl
    at
    surface.
    Once
    the mounting clip
    is
    installed,
    attach
    harness
    jack
    module by
    pressing
    one
    side
    of
    its
    notched center section
    against
    the
    inside
    of
    one of the
    arms
    of
    the mounting
    clip.
    Continue
    pressing
    inward
    until both
    arms
    of
    the mounting clip
    snap
    around the notched center
    sec
    tion
    of
    the
    harness
    jack module.
    To
    remove.
    grasp
    the body
    of
    the
    harness
    jack module
    and
    pull while rotating
    away
    f
    rom
    the mounting
    clip.
    Note:
    Should
    a replacement cable be needed. you may
    use
    any
    standard,
    8-conductor network
    cab
    le
    with
    RJ45
    connector
    s.
    The
    arrangement
    of
    the conductors
    at
    each
    connector end must
    be
    a "straight through" configuration (pin 1
    to
    pin 1, pin 2 to
    pi
    n
    2,
    etc.).
    DRC-205
    Digital,
    Dual
    Rotary
    Controller
    For
    JL
    Audio
    Products
    with
    JLidTM
    Compatibility
    JLII!I~
    Connects
    to
    the
    Jlid
    ~
    CTRL
    Port on
    VXi
    amplifiers
    or
    the
    Jlid
    ~
    Port on
    TwK
    ~
    and
    FiX
    ~
    processors.
    *
    WITH
    INTEGRATED
    INDI
    CATOR
    LED
    CONTROL
    KNOB
    .1...
    11!1
    -CTRL
    g
    118ft
    (5.5
    m)
    CABLE
    I
    HARNESS
    JACK
    Note:
    Components
    pictured
    may
    not
    be
    to
    sca
    le.
JL Audio DRC-205

Brug for hjælp?

Antal spørgsmål: 0

Har du et spørgsmål om JL Audio DRC-205 eller har du brug for hjælp? Stil dit spørgsmål her. Giv en klar og omfattende beskrivelse af problemet og dit spørgsmål. Jo flere oplysninger du giver om dit problem og dit spørgsmål, jo lettere er det for andre JL Audio DRC-205 ejere at svare korrekt på dit spørgsmål.

Se manualen til JL Audio DRC-205 her gratis. Denne vejledning hører under kategorien Fjernbetjeninger og er blevet bedømt af 1 personer med et gennemsnit på en 7.5. Denne manual er tilgængelig på følgende sprog: Engelsk. Har du et spørgsmål om JL Audio DRC-205 eller har du brug for hjælp? Stil dit spørgsmål her

JL Audio DRC-205 specifikationer

Mærke JL Audio
Model DRC-205
Produkt Fjernbetjening
Sprog Engelsk
Filtype PDF

Relaterede produktmanualer

Fjernbetjening JL Audio

Ofte stillede spørgsmål

Nedenfor finder du de hyppigst stillede spørgsmål om JL Audio DRC-205.

Er dit spørgsmål ikke angivet? Stil dit spørgsmål her

Vi anvender cookies for at sikre at vi giver dig den bedst mulige oplevelse af vores website. Hvis du fortsætter med at bruge dette site vil vi antage at du er indforstået med det.

Læs mere