Dayton Audio APA150 manual

Dayton Audio APA150
(1)
  • Antal sider: 2
  • Filtype: PDF
  • 150 Watt Audio Amplifier

    © 2007 Dayton Audio
    ®
    Dayton Audio
    ©
    PO Box 52
    Springboro, Ohio 45066
    300T812

    APA150

    Specifications:
    Power Output: 75 watts RMS x 2 into 4 Ω
    150 watts RMS x 1 into 8
    Ω
    Total Harmonic Distortion: Less than 0.01%
    (20-20,000 Hz)
    Signal-to-Noise Ratio: >100 dB, unweighted
    Crossover: Variable 50-150 Hz,
    18 dB/octave
    Auto-On Sensitivity: 3 mV
    Auto-Off Delay Time: 15 minutes
    Input Impedance: 47 k Ω ±5%
    Line-Out Frequency Response: 20-20,000 Hz (-3 dB)
    Maximum Noise and Hum: Less than 1 mV with gain at maximum
    and input shorted
    Minimum Clearance for Ventilation: 2”
    Electrical Requirement: 120V 60 Hz, 230V 50 Hz (switchable)
    Dimensions: 5.6” H x 5.7” W x 12.8” D
    Weight: 11.05 lbs

    Warranty

    The Dayton Audio APA150 warranted free from defects in material and
    workmanship for one year from date of purchase. Warranty does not apply
    to misuse, abuse, neglect, accident, improper use, etc.
    Notes About Hum
    The addition of a new component to an existing system can sometimes result in an
    audible hum. While it would be easy to assume that the new product is at fault or even
    defective, it is usually just an indicator that it is time to take a closer look at the overall
    grounding of the audio system. To start with, verify that all audio equipment is on the
    same AC power circuit. The outlets in an area may or may not all be on the same breaker.
    Always make sure that all equipment grounds are in good condition, and NEVER remove
    the ground pin from a power plug. There are some cases where the actual power line has
    some form of interference, but the most common cause of noise is a ground loop. The
    cable TV line can be the cause of hum in multi-source home audio/video systems. Just
    temporarily disconnect the cable line, and if the hum stops then the use of an inline isola-
    tion transformer is suggested. The key is to proceed slowly and step by step, taking care
    to identify which cables or combinations of cables cause noise when connected.
Dayton Audio APA150

Brug for hjælp?

Antal spørgsmål: 0

Har du et spørgsmål om Dayton Audio APA150 eller har du brug for hjælp? Stil dit spørgsmål her. Giv en klar og omfattende beskrivelse af problemet og dit spørgsmål. Jo flere oplysninger du giver om dit problem og dit spørgsmål, jo lettere er det for andre Dayton Audio APA150 ejere at svare korrekt på dit spørgsmål.

Se manualen til Dayton Audio APA150 her gratis. Denne vejledning hører under kategorien Receiver og er blevet bedømt af 1 personer med et gennemsnit på en 7.5. Denne manual er tilgængelig på følgende sprog: Engelsk. Har du et spørgsmål om Dayton Audio APA150 eller har du brug for hjælp? Stil dit spørgsmål her

Dayton Audio APA150 specifikationer

Generelt
Mærke Dayton Audio
Model APA150
Produkt Receiver
EAN 0844632061523
Sprog Engelsk
Filtype PDF

Ofte stillede spørgsmål

Nedenfor finder du de hyppigst stillede spørgsmål om Dayton Audio APA150.

Er dit spørgsmål ikke angivet? Stil dit spørgsmål her